TOLERANCE OF COUPLING ALIGNMENT

TOLERANCE OF COUPLING ALIGNMENT

TOLERANCE OF COUPLING ALIGNMENT -

Hello friends all of you know about the coupling, coupling is a device use to connect the drive to driven or work as mediator between drive and driven to transmit the power from drive to driven. While connecting a drive shaft to driven shaft it is very important to check its alignment.

All of you are well known about alignment of coupling and why it is important. I have to describe in brief the fault occurs in equipment if these are not properly align are given below.

  1. If a shaft is not properly aligned the chance of premature bearing damage is increases.
  2. By the misalignment of equipment there is excessive vibration during operation so Chance of premature damage in shaft and component is increases.
  3. Slight misalignment will generates excessive forces on the coupling, shaft and bearing.

While we perform alignment of coupling it is impossible to do correct alignment or zero-zero alignment so there is some tolerances in alignment of coupling means when we reach in between tolerance then our alignment is ok.

This limit is accepted world widely and this is different for different coupling. By using this, selection of coupling is easier while designing a design of equipment. For example if we align the tyre coupling , then as per the table our aligning value must be in range according to table that is offset allowed 4 mm , angular or radial 4° and axial float 5 mm.

Type of coupling Offset in mm Angular (°) Axial Float in mm
Rubber bush pin Coupling 0.076 1.5 0
Tyre coupling 04 4.0 5
Geared Coupling 03 1.5 2
Resilient Coupling (B-B Coupling ) 03 4.0 5
Love –joy Coupling 0.04 4.0 0
Membrane Coupling 0.001L 0.0005D

 

Where  

L= Distance between both coupling

D= Diameter

TYPE OF NON DESTRUCTIVE TEST AND WHAT TYPE OF TEST TO BE CONDUCTED FOR PARTICULAR TYPE OF  DEFECT-CLICK HERE

 

TO  KNOW WHY WE USE ALLOY STEEL  AND WHAT IS BENEFIT OF ALLOY STEEL - CLICK HERE

 

TO KNOW ABOUT THE NATURE OF LOW TEMPERATURE CARBON STEEL AND WHERE IT IS USED -CLICK HERE

 

TO KNOW WHY WE NEED TO USE KILLED CARBON STEEL  AND WHAT IS KILLED CARBON STEEL- CLICK HERE

 

TO KNOW ABOUT CARBON STEEL - CLICK HERE

 

WHAT IS STAIN AND WHAT IS STAINLESS STEEL AND WHY STAINLESS STEEL CALL STAINLESS STEEL- CLICK HERE

TO KNOW ABOUT THE TYPE OF STAINLESS STEEL - CLICK HERE

TO KNOW ABOUT ELEMENT OF POST WELD HEAT TREATMENT AND DESCRIPTION OF EACH ELEMENT - CLICK HERE

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *